These corners are 1.6"x1.6", and are all designed for cabinets with 1/2" edge radius. Sold individually -most cabinets will require 8 corners. These corners are available in black and nickel in the following formats: · C1824 -2 leg version without the wrap around front lip· C1819 -2 leg with wrap around designed for 3/4" wood· C1823 -3 leg corner for use where 3 panels meet flush
These corners are available in black and nickel in the following formats:
· C1824 -2 leg version without the wrap around front lip
· C1819 -2 leg with wrap around designed for 3/4" wood
· C1823 -3 leg corner for use where 3 panels meet flush
(See the mini tutorial below for more information)
CHECK OUT OUR QUANTITY DISCOUNTS!
· Buy 4-9 get 10% off!
· Buy 10-49 get 15% off!
· Buy 50+ get 25% off!
mix and match different styles!
ALL OF THESE CORNERS COME WITH SCREWS!
All of the corners listed here (as with most amp corners) require that the cabinet edges be rounded over. By far the most popular radius is 1/2", and this is what you'll find on about 85% of commercially built guitar amps and speaker cabinets. (if you're building a cabinet with unradiused edges, we have c0680 "flat" corners for that application)
Furthermore these cabinet corners come in three different formats:
(click on a picture to enlarge)
The "with leg" corners (C1819) shown here and here .
Note that the C1819 have two "legs" and a"lip" which wraps around to the inside edge of the cabinet, and will only work on cabinets made of 3/4" wood.
The "no lip" corners (C1824) shown here are the same except that they don't have the wrap around lip, so they'll work on any thickness wood.
The 3 leg corners (C1823) are normally used where three panels meet flush (for example the top, side and rear panels of a cabinet).
Hope this little tutorial helps. Any questions or comments please refer to the "customer service" link in the top left corner of this page. thanks